Quote:
Originally Posted by vortalexfan
, although I found out that apparently my Zenith radio was way out of adjustment because the 455 kHz IF tone couldn't be heard until around 600 kHz on the radio dial rather than at the end of the dial.
|
There is something else wrong. First of all 455KHz is out of range of the AM radio dial, it usually doesn't go below 540KHz.
The second thing is that the 455KHz from the generator probably is so strong that it will get through the front section of the radio circuit so you should hear it regardless of the dial setting.
You should probably not use a direct connection unless the alignment instructions indicate doing it that way. I would use a loop unless the radio isn't working at all. In that case you would be using a type of signal tracing.