|
I was able to get the centering magnets back in place using the white paint marks. Then came the nightmare of re-aligning using the convergence board. Luckily, the service manual gives the exact sequence for doing it. The problem was that I had everything so screwed up, that I had to go through each step many times, making small incremental steps. It seemed to take forever, but I got the set back to watchable. I still need to fine tune it, but at least I'm a lot closer than I was yesterday. I can't believe that I moved some many of those adjustments without making marks so I would know where I started. I know better. I doubt I'll ever make that mistake again!
|