|
This may sound stupid but do you have a torch and a pair or vice grips or heavy duty pliers? I would be tempted to heat the the tool till the metal softens a bit and bend each end 3/16 out to fit... depending on how hard the steel is you may also be able to bench clamp to tool and Hammer or pry the ends out.... atleast if it is your tool and not a rental...If it is a rental and you decide to bend it we won't tell...
Last edited by Electronic M; 05-09-2020 at 09:45 PM.
Reason: I HATE Androids autocorrect and cursor position algorithm SO much!
|