|
On the convergence board, the upper row of controls adjusts the R/B at the same time and the lower row adjusts the green. My biggest concern was that the left side of the grid is almost perfect but from the middle vertical line to the right side the grid gets progressively worse with the lower right corner being off the most. It doesn't show well in the pic, but the blue is also off, though not as much as the red. During my bad day off moving every adjustment I could find, (a lesson learned,) I also moved each lens in and out, which changes the overall size of each color. I think the red and blue may be slightly larger than the green, causing those last few vertical lines to end up just outside the green lines they should land on. Does that make any sense?
I emailed the convergence page from the manual.
|