Quote:
Originally Posted by old_coot88
The flywheel is clearly a potmetal casting. How far does the shaft extend inside the casting? Does it go past the level of those two bolts? If not, you could maybe use JB Weld to build up the area formally occupied by the broken collar. Keeping the shaft perfectly aligned would be a challenge though.
|
If you are referring to the brass shaft in the middle of the flywheel assembly, then yes the brass shaft goes through to the other side of the flywheel.
It's a hollow shaft because the shaft that connects to the power switch goes through there.
https://www.jbweld.com/product/steel...xy-putty-stick
Would the JB Weld Product linked to in the link above be a good product to use in this application?