Quote:
Originally Posted by vortalexfan
Are you sure the two batteries should be connected in parallel? Because I'm only getting 1.5 volts connecting them that way... 
I've also tried connecting 2 sets of D batteries in parallel and I'm only getting 1.4 volts, so not even close to the correct amount of volts needed to power the radio's filiments... |
Note I didn't advise you to put the batteries in parallel....I only advised you HOW to connect them in parallel.
The trouble with using standard alkaline D cells to supply the 2.2V filaments is that new alkaline cells are 1.5V so parallel will not give you enough voltage and series will give you too much (unless you use used batteries that are down to ~1V ). The only advantage of parallel connection is that the batteries will last longer.
One thing you could do for the filaments is connect the batteries in series and build a LM317 circuit to regulate 3V down to 2V...A filament rheostat is another solution.
Got an oscilloscope to check if the converter or oscillator tube is oscillating? And do you have a decent length of antenna wire 15-40' hooked up? If you have an antenna and the IF works then either the local osc is dead or the RF path between the antenna and the Mixer/Converter is bad....If you passed IF down the antenna and it didn't seem attenuated in comparison to injecting it at the 1st IF then that favors the Osc being dead.