Quote:
Originally Posted by Electronic M
Note I didn't advise you to put the batteries in parallel....I only advised you HOW to connect them in parallel.
The trouble with using standard alkaline D cells to supply the 2.2V filaments is that new alkaline cells are 1.5V so parallel will not give you enough voltage and series will give you too much (unless you use used batteries that are down to ~1V ). The only advantage of parallel connection is that the batteries will last longer.
One thing you could do for the filaments is connect the batteries in series and build a LM317 circuit to regulate 3V down to 2V...A filament rheostat is another solution.
Got an oscilloscope to check if the converter or oscillator tube is oscillating? And do you have a decent length of antenna wire 15-40' hooked up? If you have an antenna and the IF works then either the local osc is dead or the RF path between the antenna and the Mixer/Converter is bad....If you passed IF down the antenna and it didn't seem attenuated in comparison to injecting it at the 1st IF then that favors the Osc being dead.
|
No but someone else on here said to connect 2 D cells in parallel to get the voltage I needed for my filaments, you just happened to reply when I asked about how to connect batteries in parallel.
Anyways Rechargeable NiMH batteries are 1.2 Volts which if I connected 2 of those together I would get 2.4V which would be the correct voltage I need for the tube filaments, and they make NiMH Rechargeable D cells that are as high as 12,000 mAh, which would be more than enough juice to power the filaments.
I'm guessing the oscillator isn't running because the tubes aren't getting enough filament juice.