Quote:
Originally Posted by zeno
Voltage is seriously low. Look at power supply first.
Next check the voltages on the hoz output tube.
DO NOT measure the plate cap !
The G-1 voltage is most important. It needs to be very
( see manual) negative. If not look to the Hoz osc stage.
73 Zeno 
LFOD ! |
the voltage on the plate cap CAN be measured, if IF it is unhooked from the HOT and there are NO horizontal pulses, it should be aprox the same that is going into the damper, the danger is that ANY horizontal pulses or feedback from the FBT can toast your meter, but if horizontal not running, and its unhooked, it's usually safe.