[Electronic M]

Originally Posted by Notimetolooz

I'm not sure a "gasket maker" product will have the best adhesive properties.
I think a little better choice is this black adhesive. I've used it on other things and it states that it can be used on wires.
https://www.permatex.com/products/ad...esive-sealant/

Yours doesn't have sensor safe on it.

I have one tube that was done in the red several years ago that is still holding on. That tube has probably seen at least 80 hours of use with the red. It started out in my Moto 21CT2 as a replacement for the necked 21AXP, then I got a CTC5 with a good AXP and swapped the CRTs between the two, then I found another mediocre AXP and stuck it in the CTC-5 and since then the permatex RED 21FBP has been sitting waiting to go into a Packard Bell when I get to it.

I just did another 21FBP22 with the red yesterday since the last one did well.