Quote:
Originally Posted by old_coot88
The speaker being disconnected should not hurt the xfmr UNLESS the audio was blasting at such a high level that the xfmr was arcing inside (highly unlikely).
Did you take an up-close whiff of the xfmr? If it's zorched, there'll be a scorched smell coming from it (per the old techie proverb "the nose knows"). And did you verify continuity of both windings with an ohmmeter? The primary should be a few hundred ohms, the secondary a fraction of an ohm.
More than likely the smell was from some other component, probably a resistor that got cooked.
|
There was no audio coming from the speaker and the audio output tube was barely warm to the touch, also the output transformer's primary leads measured a little over 500 ohms and the secondary leads measured about 0.6 ohms, which didn't seem right because the Sam's specs the transformer primary as 10,000 ohms and the secondary as 3-4 ohms.