old_tv_nut and Electronic M, thank you for the replies. The set is a power tx set so no need for isolation and it sounds like I will need an inverted signal.
I found an old post from you with a circuit design. I understand I can adjust the collector resistor to change the output, also can I skip the .22uf on the collector as I am feeding directly into Q4? Additionally read that a clean 12v is important. I have 19v on the board to work with so I could add a voltage regulator to drop down to 12v. Some quick searching suggests this transistor should work:
https://www.digikey.com/en/products/...4401TA/3478153
As for details on the waveform I tried to clean up and shrink the schematic to better fit. See below from Sams which includes the waveform, also posted is the inverter/amp circuit.
