Quote:
Originally Posted by zeno
We repaired tons of T991, ALL of them we did the following. Pulled
chassis & resoldered the mother board ESPECIALLY at the power supply
& horz area. Dont forget the ground lugs at the steel frame. Pull all modules &
check all PC cons ESPECIALLY at the connectors. If it has a plug in flyback
be sure the pins are clean, they burn. Cold joints were a big problem that
often blew the power supply board & sometimes started chain reaction
failures. When thats all done they were very good sets.
73 Zeno 
Stay well & LFOD ! |
@zeno @BRC2000
Apologies for bumping an old post; just wondering do you guys have any information about the power circuitry of the T991?
For example, I think the power circuitry is either internal or chassis-mounted with only the power lead visible on the outside and no external power brick - is that correct?
Also, would you have any idea about what the output DC voltage and amperage would be?
Many thanks