[timmy]

Yes most of what you mention I already checked the choke 11 ohms a new thermistor all the power supply caps even checked them parallel them I even checked the sams for where the 275 190 and 145 voltages go and traced them back to what I did in the power supply, checks fine. At the diodes it’s the same 360v the doubler caps have 180v on each cap diodes clipped there is 143v ac present thermistor is new the 550ohm resistor checks perfect all the ps caps are exact or higher in capacitance. I’m going to check line voltage going to the primary of the power transformer tomorrow and hopefully rule out a thermistor problem or transformer primary problem. And also the 15k and 5.6k both are perfect. All this is with 114v or so line voltage.