|
If you are so worried about the L42 Temp. then just put a 10 Ohm 10W resistor in
series with it, and check it's temp. and move on till you get a pic on the screen
and then you can figure it out.... I mean like a Good Pic from the tuner
with everything else working.....
I also doubt that any cap. that you replaced where the value is .1 and you put
in a .5 by mistake is causing all these problems... I hate the idea of using a
parts cannon on all these tv's before you get it working by only replacing
electrolytics, but that's what you guys end up doing....
This should be your main focus:
Every TV without a signal should produce snow on Picture & Sound
this one does not. You tracked the signal loss to a specific area, & now
need to focus on why it's getting lost. IF Amp not working? IF amp
turned off because of some AGC Fault?
.
__________________
Yes you can call me "Squirrel boy"
Last edited by Username1; 11-06-2022 at 09:15 AM.
|