|
Best I can figure from the schematic pin out below. I think Phil said he used 25 watt resistors:
Pins 3 and 4 200 ohms
Pins 1 and 5 37 ohms
Pins 2 and 5 105 ohms
Pins 5 and 7 105 ohms
Pins 6 and 8 Can't find on schematic. Measures 21 ohms on what's left of the ballast.
So my plan would be to use a piece of aluminum as a heat sink mounted on the chassis and screw these to it with thermal paste. Then I'll make the appropriate connections to either a spare pin socket or directly to the socket contacts on the chassis. I will also look into the capacitor calculations and if that's viable, I'll post the plans here first. Any comments or suggestions?
|