View Single Post
  #8  
Old 07-29-2023, 08:37 AM
kvflyer kvflyer is offline
VideoKarma Member
 
Join Date: Nov 2006
Location: Fernandina Beach, FL
Posts: 1,128
Moving right along, I was about to just put this set back into the cabinet to make room for another long in queue project. I had noticed a missing screw in the HV case but really didn't pay a lot of attention to it. Long story short (Thanks, right?) the width "Control" was missing. I have adequate width in the picture but upon further investigation, it is RCA #71429 Width Coil, L115 or L196 depending on whether you are looking at the Sams or RCA documentation.

I have a T100 and that has the same part number coil. I will have to dig it out today and see if there really is one there. This 630TS is more desirable to me than the T100. Well, guess I am not quite done for now. Some pictures of the chassis after quite a few components were replaced. You can see the one capacitor that I left in, the green Sangamo 33M capacitor which was a previous replacement. Also, I keep the CRT plug and ion trap tied up so that they are not flapping around.
Attached Images
File Type: jpg UnderRestored-w.jpg (78.9 KB, 18 views)
File Type: jpg TopRestored-w.jpg (55.0 KB, 16 views)
File Type: jpg AboveRestored-w.jpg (64.3 KB, 17 views)
Reply With Quote