|
I spoke with a few people the consensus is that the RCA Diagram is right. I didn't take into account that the resistors aren't big enough to drop the voltage down from 255 to 125v. So I started tracing out Pin#1 of the 2nd If. the 150K 5% resistor read 189k so that is probably part of the issue. I only have a 30 MHz scope, If I just go through and change all the resistors, will I still be able to align this IF? I'm afraid to knock them out of alignment by changing all the resistors. I can tell someone else has worked on this IF board, so it maybe problematic. I would love to just put fresh Discs and resistors in here so I can set it and forget it ha-ha. But I don't want to be digging my self into a hole.
|