Quote:
Originally Posted by Chris K
No change in symptoms with a composite signal into the 1st video grid. R130 is reading 180 ohms and not 150 ohm. I got the freeze spray today.
|
BINGO!
That is out of tolerance for 10%
and you may have others, some say that having it go higher than 20% is OK, but in my case, I checked each and EVERY resistor, using this site,
https://www.allaboutcircuits.com/too...de-calculator/
If it tested within 10% or better, I marked it with green paint, if it checked below, I replaced with a new 1% resistor, This could be your problem, not sure, but It is what I had to go through