[Username1]

.

Did you run the tv before replacing all the caps? & Did it have this problem before?
If not, you should review your work & be sure all parts are correct, & in the right
spots. Do you have a Sams, or Schematic from someone else? Begin by checking
voltages at power supply, & then B+ Boost & the driver voltage to the Horiz.
output tube G1 should be a -50V or so, I don't have a schematic for this tv,
so you have to find the right V.

Is the width 1" in from the sides, 2" ?? Is it distorted in any way....?

Of course the width coil can be bad, so you have to check it as well,
again If it's a coil, I don't know....

Messing with the yoke now will only add to what you have to fix once you
find the actual problem you have right now...

.