Quote:
Originally Posted by bandersen
It shouldn't really make that much difference though. I'm literally working on one right now with the same setup.
Can you grab the CRT base while the set is running and move it around a little? Can you center the image?
 |
I managed to get the image centered but not low enough. I did expect it to move more when I wiggled it but...it's not great but it's better than it was. I can tilt the image if I roll the yoke left or right. I do have a signal passing through that's horizontally stable but rolls and wont vertically lock and the crosshatch is mostly bunched at the bottom of the image...but I still have several caps to replace in the vertical circuit so, I'll get that done and we'll see where we are.