[Chris K]

Originally Posted by Yamamaya42

correct, I have been playing with my monster analog scope a bit, and if you have it in the right mode, IF you unplug the line you have hooked to CH1, you should get a single non-moving dot on your scope, because ALL the sweep is from an external source, anything else, and it not in the right setting, and it wont work. but if it does show a dot, and then a line when hooked up, then... things a a bit more complicated.

When I disconnect the X input, I just get a dot. There's sweep and I can vary it with the sweep width adjustment on the 8601. I just don't have any markers.