|
well that makes sense. I was FOCUSing on voltage measured across it when focus went out. So make it draw more or less current and IM good to center the focus control. I checked the 3k sand resistor that was replaced as welll as the 2200 ohm resistor which measured 2387 ohms so I dont think that is the issue
Oh now thats funny my schematic photo isnt in focus either lol
I replaced the vertical output transformer a while back so if thats not right.....that would draw more or less current and make the focus out of whack since the focus coil and vertical transformer are connected. I dont see any other resistors to check. The 5u4 doesnt have any resistors near it
Last edited by fumplet; 09-15-2024 at 03:11 PM.
|