[fumplet]

is there supposed to be a cover on top of the high voltage cage? Mine doesnt have a top to it.
Also I noticed that when I measured the filament voltage on the philco picture tube in it, my sencore cr 70 has the red mark for the proper filament voltage of Im guessing 6.3 volts (a/c normally in the set , Not d.c. voltage) I measure 6.14 volts the sencore is supplying so I cranked up the measured with dmm voltage to acutall 6.3 volts although d.c. volts. Is my tester a little low on volts or is it because the measurement is correct because a/c volts is slightly lower for a d.c. equivalent voltage?