Quote:
Originally Posted by Penthode
I checked step 6 and see the problem. The instruction manual has an error. The table gives an incorrect connection of the VTVM to the junction of L104 and R126. You need to measure across R119 with the case of the VTVM at -120vdc.
Please explain because you were talking as if the VTVM was faulty.
|
I'm going to get set up shortly to start with step 6 in the alignment again as per your instructions but I'm a bit concerned whether or not we are on the same page...literally on the same page and chassis. I don't see a mention of L104 and R126 anywhere in the Riders documentation I'm using. I know there was some confusion before as to what chassis this thread was about so I just want to clarify with a few words and pictures. My chassis is the KCS28B in the 9TC240 model and below are pictures of the alignment instructions and the table of alignment steps.
