|
Not sure what's going on here but I'll tell you what I'm seeing...and hearing.
Let's be certain we are on the same page. I'm trying to do step 6 in the alignment table, the adjustment of the top of T-103. I have the VTVM connected to pin 1 of V106 and set to the 5V AC scale. I'm using my AC probe and ground lead from the VTVM. The 8601 is set for a CW of 21.25MHz. I tried what you suggested about turning up the RF gain. At 30mV through 300mV, I hear the 1KHz tone very clearly through the speaker with 100mV being the sweet spot for best undistorted tone. Anything lower than 30mV or higher than 300mV, I hear no tone through the speaker. At none of these RF output voltages can I see deflection on the VTVM of any significance when I turn the slug. What the hell is going on with this possessed thing?
|