|
Also noticed something and am not sure it would be an issue, but the red tap used to adjust color in the white areas after G2 adjustments is frayed where it is soldered to a post and it is also a bit corroded (greenish blue colored wire strands). It is only holding on by a few strands. I want to redo it, but I don't think there is enough length to cut off bad, strip it and resolder to post. Is there anything special about the wire used, or can I use just about any stranded pure copy wire the same gauge?
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|