Quote:
Originally Posted by BeamT
The picture you posted is not clear enough and is too close-up, so I can't orient what I am seeing. I can't see any of the cap polarity markings, or the diode clearly at all. Test the diode and the resistors.
Assuming the rib on the cap is positive. I believe the cap was in backwards. Should be 100 uf @ 25v. I would go to 35v or 50v for a little more margin. Attached is more of that circuit, which is dynamic convergence and associated wiring, from Zenith CM-122, confirming that SAMS in that area is correct. In the SAMS picture, Cap positive, was oriented to the back of the chassis.
I don't pretend to understand dynamic convergence circuits but you could have impacted several coils and controls on the convergence board/clover. From your prior threads you have been working on that board. Did/do all of the controls work?
Do you have any pictures of the chassis from your prior recap?
|
Would it be possible for you to post the adjustment section of the CM-122? I want to see if it compares to the Sams, or if it has better/different procedures.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
|