|
Setup switch and tripler are installed. Just need for the RTV to set and I'll reinstall chassis and test.
I don't think I did too bad with the wiring and soldering. The resistor was a bit longer than the original, so I had to set it a bit higher up with a longer lead on the tripler end. A bigger blob of RTV covered the longer lead.
Always wondered about the focus control lead. It pretty much just runs along the top of all the circuits on its way to the pot. Wondering if it's a noisy lead or not enough to interfere with other components.
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL
Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650
Last edited by TinCanAlley; 05-28-2026 at 06:25 PM.
|