[TinCanAlley]

Thought I'd add something regarding the perforated cover over the swing door. I've noticed in a few pics I've seen on the internet that, like mine, many had dents in it. I had quite a few and some were pretty bad. Don't know what happened to it, but it had a rough life.

The cover is aluminum is held to the door by tabs that are left when the piece is cut to fit the door. Those tabs are bent over to hold it in place. If you carefully bend those tabs back, the mesh piece will come off. I took that piece, found the smoothest and flattest surface on which I placed the thickest piece of paper I could find to place between the surface and cover so as not to scratch it. With the cover face down, I gently tapped the dented areas with a flathead hammer until it was smooth as possible. Flipping it over often to see the progress. When it was done I put it back and bent the tabs over. I wouldn't recommend taking it off too often as the tabs will break.

The results are great. It's only under close inspection you can see it isn't perfect.

The after pic isn't the best angle, but I am too lazy to take a proper pic. Also, looking at the pic, I need to remove the transducer and clean the screen and opening.