Had to give up on project , was butchered
Had to give up project. A real bummer. The selectively pot metal switch was glued well with jb weld but barely works. The tuner chassis had caps missing and even the dial cord metal pulleys and sub assembly that changes the cord direction from direct shaft to pulleys at 90 degrees to make usefull for tuning gang. Tuning gang all bent up and out of alignment.
Person worked on a lot of simpler radios OK.
This one was a waste of money.
Would have to buy a better parts set just to make complete.
Radio history lost.
That selectivity switch is a wafer type of variometer I believe .
Parts to fix above value of set..:
|