|
Already done that. I used the speed pot to slow down the motor right where it almost holds. And then I hooked the sync back up.
Like I said before, it tries to lock, and as soon as it does, the motor gets another kick from the pll and it looses lock. and itll try to lock again, and when it does, it gets another kick from the pll. hmmm.
is this because I had to switch the syncs for it to work? because remember, if I switch it back like in the schematic, it will fail to operate, and drives the mosfet into saturation, thus running the motor full speed.
Last edited by mbates14; 08-23-2005 at 01:22 PM.
|