|
I can see using a vacuum or such to pre debubble the sillicone, then pour it slowly...
Frankly, I have NO CLUE how the heck they did it in the factory!
My guess for a modern day rebond:
Use a suction cup hloder to hold glass in front of CRT at right sapceing. CRT held by jig.
Wrap tape around the two as origional.
Poke two holes in top - one to let air out, one to add sillicone.
Fill with the new stuff - slowly.
Beyond that? No clue.
I'd hang onto any bonded tubes with bad bonding - they inevitably test great, and let's face it, SOMEONE will SOMEDAY figure this out...
|