bkasindorf,
Thanks for the offer, but I already have a copy.
I have started recapping this bad boy, finally. I had lots of confusions when rewireing the electrolytics, but I believe everything is good to go. I replaced most of the paper caps and two of the micamold caps. There was also a black beauty that I changed too. I also have damaged one of the inductors wound around a resistor in the video amplifier section. My soldering Melted the wax and I went to move it out of the way and the inductor broke from the resistor lead. Could I get a new inductor and resistor and connect them in parallel in place of the broken inductor/resistor or is the inductance and lead dress really critical?
Also, where can I get it's 10BP4 rebuilt? It has no raster, but doesn't appear to have lost it's vacuum. I tested it on a working chassis to see. I still have two good 10BP4's from the two 630TS clone sets I have, but I wanted to keep everything as original as possible. Any suggestions?
Thanks.
Jonathan