|
The screen area was smaller. The top and bottom were missing about 2". Voltages to the vertical board were correct, so I adjusted VR 717 (vertical size) and that corrected that problem. The remaining problem is that on set turn on from "cold" the bottom of the screem is black (about 1/5 of the screen), but you can see some picture through the black area. It takes about 15 minutes for the condition to clear up, slowly, the black area lowers until the screen is normal. Afterwards, the screen is full size and works fine. When the set cools after turn off, the problem returns.
jstout66, I cooled the vertical board with no return of the problem after the set heated up. That set is difficult to do that with since the ac plug needs to be pulled before removing the back. By that time, the set cooled enough for the problem to return.
Ron
|