|
I tried the procedure Charles outlined, which varies a little from what I normally do. But...no luck. I can get a pic that is too green or too red but the only way to get a blank raster to show close to proper grayscale is with the bias up over halfway & both red & green all the way down. Then if you display video its all screwed up. The blue drive control has almost no effect. I swapped the taps for red & blue (no control for red on this chassis, it is full-on) but no luck there either. So I just dialed it in the best I could. Chad, I'll try the 8 volt trick & see what happens. I'll leave the tester hooked up overnight & try it tomorrow.
__________________
Bryan
|