|
I checked again to make absolutely sure I didn't put a 150v 50mfd or something like that instead of the 150mfd, but I didn't. That 30mfd capacitor I had replaced with a 20, it was all I could get at 500v. But I didn't think that one being a little off would cause any problems, I just now put a 10mfd at 400v cap in parallel with it briefly, just to see if there was any change, there really wasn't. I changed that 2.2meg, and that did help a bit, after making some adjustments after it was changed, it really isn't too bad. I either have to settle for the bottom inch or so of the screen being a bit squished, or having about that much of the picture cut off at the bottom. But that's much better than it was. I think its time for me to move on, in the past 3 months I got 4 sets I have yet to start working on. And unless I'm watching a test pattern (which I have been known to do), this picture on this TV really does look good enough now.
|