[Adam]

I replaced those resistors with the correct wattage, all I could find for that .015 - 1000v cap was a .012 - 1600v but it seems to work. I think I'm just going to have to leave that coil bypassed, it seems to work fine that way, anyway.

I don't know what it is with all these bad repairs I keep finding lately, my Hoffman 610 was the same way (previous repair guy had put in lots of resistors that were the wrong value, and then didn't even always hook them to the right place, he usually would go one pin up from where it should be on a tube socket.) I've never seen one where all the tubes were mixed up like that though.

*****
I spent another night working on this, recapped the remote receiver, put it all back together and everything works. My SC 600 remote works on this as well ("ch lower" changes the channel, while "ch higher" corresponds to the the on/off - volume control.) But I forgot to get a new light for the channel indicator, so I'm not going to be able to put the back on and be officially done with this one until next week.