|
It's up and working again, the trouble turned out to just be that the wire where the power transformer hooked to the filament of one of the 5U4s was broken. Also every time I had turned this set on for a few weeks the horiz width kept decreasing, and I kept turning the control up, that problem turned out to just be a weak 5U4, there wasn't enough voltage anywhere in the set, not just the horizontal. I had put in a used one that was on the weak side before, because new 5U4s have gotten so expensive. I took that one out and I found another used one I had that tests better, voltages in the set are back up to what they should be.
|