|
That's interesting, I like reading these old repair stories. I had a similar problem trying to replace a base on a 21FJP22 a few months ago, after trying for several hours, my solution was to solder long pieces of solder wire onto each of the wires, then with the extra wire to work with it is easier to thread the wires through the pins. Then you cut the solder wire comming out the back of the base after it is on leaving just a litle bit sticking out, then just heat the pins and the bit of solder still stuck to the wires melts and solders it together.
Last edited by Adam; 07-10-2006 at 05:40 PM.
|