|
I removed both rectifier tubes and plugged it in. After being on for 3 minutes, there is absolutely no smoke. Nothing getting warm. I measured the voltage on the B+ winding, it's 760VAC, unloaded, of course, and 380VAC at the center tap. Again, no smoke. I'm almost 100% certain I have everything wired the way it should be. But when the rectifiers are in I get the proper voltages, don't I? Around 380VDC at B+ and about 340VDC at the 275V point off the bleeder resistor. Think it's the rectifiers, the power transformer, or again, do I have something wired incorrectly?
Thanks.
Jonathan
|