![]() |
|
#1
|
||||
|
||||
|
Prolem with Sony Trinitron Wega model KV24FS120
Screen is only half lit. bottom is blank and top half has lines running through it. Any ideas where to start looking?
|
|
#2
|
||||
|
||||
|
Sounds like you've lost half your vertical sweep, or the linearity has gone way out of whack, possibly bad caps or a bad vertical IC, or both.
I'm not familiar enough with the specifics of the set to offer more but someone will probably step up with some help. |
|
#3
|
||||
|
||||
|
Dont remember the vert on those but we did sell a ton of them.
Check for PC cons at vert IC very common on that vintage Sony. Most ran on +15 & -15 from the FBT be sure you have both. If not will usually be the diode & low value resistor +- 1 ohm. And as always electros but I would put them 3rd. 73 Zeno
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|