Why no love for this GE roundie ?

[tvcollector]

I removed the can and went over my work on the restuffing job and everything is wired correctly, even got out my tester and tested each lead to make sure each value is right.. I then hooked each cap to their proper leads directly then I ran each ground wire and connected all of them with alligator clippers to the chassis ground.. Looks like a complete mess, but it's only temporary.. Powered set up again and still the problem is there.. I removed the HV output tube when I powered up again and the crystal doesn't glow..

The can was really loose when I powered up the set after restuff job, so possibly may not have been making proper ground connection, or I could have done something to the other exposed caps when I flipped the chassis over to remove/install the second can.. I most likely burned something else out.. There is a small .001 cap that was connect to one of the terminals of the can to ground, I ended up burning it with the soldering iron.. I did check it afterwords and still tested within spec..

If anyone else has an extra can lying around I would probably take it.. I'm most likely going to Radio Shack tomorrow and buy a ground terminal strip and mount them on the bottom, at least with the one can.. May have to drill hole in chassis to install the terminal at a good place under the cans.. If anything I'll just leave the one can empty for looks..