Zenith Color Roundie Alignment with B&K 415

[bhegges]

Sweep injection for the color amp alignment is at C1 which is just after the IF picture detector diode. This bypasses all of the IF alignment circuitry accept the 4.5mc filter (which I fiddled with just to see if it had an affect, nope it just shifts response curve left or right of the 4.5mc marker)

I agree it is strange I can not get the response higher at 3.08mc. I would like to think it is not something dumb with my testing setup or tools. Thinking though could an out of spec coupling capacitor pass but attenuate part of the frequency response? Otherwise I am looking at LC circuits which all have been gone through.

Could I create a test point after the first color amp circuit, or at other points to see where I lose the response? Thoughts on where in the circuit?