My Attempt at Predicta Restoration

[PredictaNoob]

Originally Posted by DaveWM

I am looking at the SAMs, C3 section A is one of the electros that bypasses the cathode of the 6DR7. The sams and the notes printed on the PC board do not match up. See if you can find a wire from the thin can (low volt 100mfd) going to the pin 9 of the 6DR7 (or to the pot that connects to that pin).

AH, OK got it. Its labeled as E1 section 3 (100 mfd at 50v) and yes it is right up against the P.T., and yes it is open! (and so are the other two sections). I already have all electrolytic and cap replacements on-hand. I'm not going to re-stuff this can, but mount the new e-caps on the board. Heck the wire that connects that cap to the vert lin post runs a full 3/4 length around the board!