Philco 60 restoration

[bandersen]

Originally Posted by GuyIncognito

Hi bandersen,

I just saw your latest video--great stuff, as usual!

If I remember correctly, the depth--and therefore the "mesh"--of the tuning capacitor plates can be easily tweaked using that nut/screw arrangement on the back. It is an adjustment used to change the point at which that single rear ball bears vertically on the end of the rotor shaft. Tightening the screw pushes the ball and rotor forward, and vice versa; the nut locks it in place when everything is nice and centered.

Thanks! I'm sure you're right although the nut/screw are pretty well fused together on mine. Luckily the scraping I had was only on one set of plates rather that the whole rotor shaft being out of whack. A little tweak to the position of the fixed plates in that section cleared it right up.