|
Hi All;
I have put in the two Resistors, And with both a Bulb and Variac, I have tried the unit.. The Output from the Transformer is fine, but I get really Low voltage, DC out.. From the Resistor Divider, So, I have Checked the voltage on the Rectifier tubes, still low.. Filaments show 3.4 Volts, after taking the Bulb out it was up to 4.7 volts.. So, next, I will Dis-connect the wire from pin 8 and see what the Rectifiers put out by themselves, If it is still Low, then I know it is my Tubes.. And not Bad load, somewhere else.. But, If it is Higher, then, something in the Cap or Load or the diviver section then something is most likely wired wrong..
THANK YOU Marty
Last edited by Geist; 03-04-2013 at 01:08 PM.
|
03-04-2013, 12:56 PM
Threaded Mode