Oh so close, but now what (new problem)

[DaveWM]

that is a common bulb limiter by a lot of folks for checking major shorts in a set, but I think zeno was looking more for shorts of the HOtransistor

quoting here

After replacing since you prob dont have a variac you should use
a "rubber fuse" to protect it. You have many of them, a 75W
lamp. Remove the wire from pin 4 of the FBT. Hang in the lamp in
one end to pin 4 & the other end to the wire. If it lights dim
& you get a small dim pix things are OK for now. If it glows
bright you have problems.........

stop quote.

the prob with just using a dim bulb as you have it (at the primary of the power trans) is if there is a prob in the circuit around the HOT it may still blow even with the dim bulb. I could be wrong though, as I thought these chassis have loosely coupled power trans that should limit the current to some degree. Zeno needs to chime in to clear up.