Quote:
Originally Posted by Kamakiri
One of the wires that was connected goes to pin 8 of the 5U4s, the others I can't see where they go, but I assume that those two complete that particular circuit. From what I can find, the relay should show 5000 ohms across the coil, I have 3800.
If this relay were dead, and with those strands of wire connected, could this have caused the set to work before, and not now?
|
Makes sense, if the relay or driver circuit were bad, the connection might have been bridged on purpose to provide B+ to the set.
jr
06-26-2014, 11:38 AM
Threaded Mode