|
|
|
#11
09-10-2014, 11:00 PM
|
||||
|
||||
|
IMHO the best way to kill the HV on a set with a power transformer if to pull the horizontal output tube (on series heater sets either remove the plate lead or get creative...) . I would not run the set with both the HO tube and a gassy rectifier in place. If HV goes to that gassy HV rect. arcing may occur inside it and could cause other issues that ya probably don't want to deal with.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
|
|
Threaded Mode