|
|
|
#16
02-15-2015, 11:06 PM
|
||||
|
||||
|
2 of the 4 terminals on the replacement are duplicates of the other 2. With a DMM you will find that there will be 2 pairs that always have continuity, and that when pressed all pins will have continuity with each other.
Essentially it is a SPST with extra terminals.... If the mech can deal with the switch not being centered you could clip the duplicate pins and only solder 2 (if that works some superglue between the new switch and the board may be a good idea) ....Other wise you could possibly solder the duplicates together, and add new centered leads to go through the board.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 
|
|
|
Threaded Mode